For the simple application of SolProtect®, get from your local specialist dealer the SolProtect®-Special sponge, or even better the cost-saving set of GRIPS (sponge with clamping handle) and SOLBOX (working and storage box).
Fill about 2 cm SolProtect® liquid laminate into the SolBox.
Place the dry sponge in the liquid laminate, until it has saturated with a sufficient quantity SolProtect®.
Wipe off the sponge at the edge of the box...
and apply SolProtect®quickly and evenly, not too thin onto the dry inkjet-printing.See video above!
(On a few difficult materials may be wetting problems upon applicating SolProtect®. In this case, wipe dry SolProtect® with absorbent paper and apply a new layer on it.)
Check whether SolProtect® was applied on the entire surface everywhere.
The airflow of a fan can reduce the drying time significantly.
After a drying time of about 10-20 minutes... (depending on room temperature)
weed the stickers... done!
The sponge can be kept for the next application in the well sealed SolBox with a small amount of SolProtect®!
DE
EN
